5-4
6. REMOTE RT
This test is the communication test with MF/HF transceiver. MIF command CAID (CALL ID) is sent to
the connected units and their model names in the response characters are displayed.
This test is not executed if RT PORT in SYSTEM submenu of “Setup menu” is set at “IEC” or “OFF”.
7. REMOTE DP
This test is the communication test with the same MF/HF transceiver as above REMOTE RT test. MIF
command CAID (CALL ID) is sent to the connected units and their model names in the response char-
acters are displayed.
This test is not executed if NBDP PORT in SYSTEM submenu of “Setup menu” is set at “OFF”.
2. Daily Test
MAIN CPU
DSC-60
FS-xxxx
DP-6
CAID
#IDFSXXXX
CAID
#IDDP6
MIF COMMAND
CONTROL/MODEM PCB
To Next Page
Loading...
