ENGINE
3-5
<4M5 engine vehicles>
1. Pull out the oil level gauge and wipe oil from it.
2. Insert oil level gauge again, then slowly pull it
out.
3. If the oil on the gauge is in the range illustrated,
the oil level is adequate.
If inadequate, replenish with prescribed oil.
Also, if the engine oil is dirty, replace it.
4. After inspection, insert the oil level gauge all the
way in to return it.
Adding oil
1. Clean the area around oil filler cap to prevent
dust and dirt from entering the engine.
2. Remove the oil filler cap and add oil as neces-
sary.
3. Make sure that the oil level is correct. If the oil
level is checked immediately after adding, the
reading may be lower than the actual level
because all added oil may have not yet reached
the oil pan. Wait for at least 5 minutes after add-
ing oil.
4. Install the oil filler cap.
CAUTION
The added oil should be of the same grade and
viscosity as the oil originally placed in the
engine.
WARNING
Take care not to spill engine oil as engine oil
on the exhaust manifold or other hot sections
of engine could catch fire. Wipe clean the oil
if spilt.
T76568
76514
FUSO ASCENT-ALEJANDRO CANTO
To Next Page
Loading...