23
Before Using
MEMORY MODULE
INITIALIZE ?
YES > +
NO > -
When inserting and removing the data pack
Always turn off the transmitter power before removing or inserting the data pack.
Data pack initialization
When using the data pack, initialization is necessary so
that the data pack can be used with this transmitter. When
"INITIALIZE?" is displayed on the screen at power ON,
press the (+) button. This automatically initializes the data
pack. No further action is necessary.
When a data pack used with another model has been inserted, and initialization is
executed by pressing the (+) button when "INITIALIZE?" is displayed on the screen
at power ON, the old data is destroyed so the data pack can be used with the 3VCS.
Data interchangeability with other models
Data is not interchangeable with 3PK, 3VC, and other transmitters other than the
3VCS.
Set data backup
The set data of each function (transmitter body and data pack) of the 3VCS transmit-
ter is stored in a memory element that does not require a backup battery. Therefore,
the 3VCS transmitter can be used without paying attention to the backup battery life.
ON
Display switch
If the display switch is turned on without turning on the power switch, transmitter
side data setup is possible without emitting radio waves.
Display switch
OFF
Warning
Never turn on the power switch while
this function is in use.
If the power switch is turned on, radio waves will be
emitted and interfere with
vehicles (boats) operating on the same band (fre-
quency) and is very dangerous.
To Next Page
Loading...
Need help?
General
