7
For Your Safety As Well As That Of Others
Operation Precautions
Warning
Prohibited Procedures
Do not operate two or more models
on the same frequency at the same
time.
Operating two or more models at same time on the
same frequency will cause interference and loss of
control of both models.
AM, FM (PPM) and PCM are different methods
of modulation. Nonetheless the same frequency
can not be used at the same point in time, regard-
less of the signal format.
Do not operate outdoors on rainy
days , run through puddles of water or
when visibility is limited.
Should any type of moisture (water or snow) enter any
compoent of the system, erratic opreation and loss of
control may occur.
Do not operate in the following
places.
-Near other sites where other radio control
activity may occur.
-Near people or roads.
-On any pond when rowboats are present.
-Near high tension power lines or communi-
cation broadcasting antennas.
Interference could cause loss of control . Improper in-
stallation of your Radio Control System in your model
could result in serious injury.
Do not operate this R/C system when
you are tired, not feeling well or under
the influence of alcohol or drugs.
Your judgment is impaired and could result in a dan-
gerous situation that may cause serious injury to
yourself as well as others.
Mandatory Procedures
Extend the transmit-
ter antenna to its full
length.
If the transmitter antenna is not
fully extended the operating
range of the radio will be re-
duced.
Check the transmitter antenna to be
sure it is not loose.
If the transmitter antenna works loose, or is discon-
nected while the model is running signal transmission
will be lost. This will cause you to lose control of the
model..
Always perform a operating range
check prior to use.
Problems with the radio control system as well as im-
proper installation in a model could cause loss of con-
trol.
(Simple range test method)
Have a friend hold the model, or clamp it down or
place it where the wheels or prop can not come in
contact with any object. Walk away and check to
see if the servos follow the movement of the con-
trols on the transmitter. Should you notice any ab-
normal operation, Do not operate the model. Also
check to be sure the model memory matches the
model in use.
Full
Length
To Next Page
Loading...
Need help?
General
