FUTABA 3VCS - Page 62

63
Functions
Timer/TIMER
Lap timer setup
(Preparation)
- Use the function select switch function (See page 82) to
select the switch.
- Select "LAP MEMORY" at setup item "TYPE".
Setup items
RST : (Indicates the reset state.)
ALRM : Alarm setup
PRAL : Prealarm setup
TYPE : Timer selection
Switches
LAP STA : Start/stop
LAP RES : Stop/reset
Setup item switching
- Use the (DN) or (UP) button to
switch the setup item.
LAP : Number of laps display
No. : Lamp memory No. display
TIME : Lap time display
1 (Alarm time setup)
Select setup item "ALRM" by pressing the (UP)
button twice, and use the (+) and (-) buttons to
set the alarm time.
2 (Prealarm time setup)
Select setup item "PRAL" by pressing the (DN)
button once., and use the (+) and (-) buttons to
set the prealarm time.
3 (Linking start with the throttle stick)
Select setup item "RST" by pressing the (UP)
button twice, and press the (+) and (-) buttons
simultaneously for about 1 second. A PeePee
sound is generated and "RST" > "RDY" blinks at
the timer display and the system enters the RDY
state. Throttle stick operation starts the timer.
4 When ending adjustment, return to the initial
screen by pressing the (END) button three times.
Adjustment buttons
- Use the (+) and (-) buttons to make
adjustments.
- Press the (+) and (-) buttons simulta-
neously (approx. 1 sec) to return to the
initial screen.
Alarm time
OFF, 1 ~ 99 m
Initial value: 4 m
Prealarm time
OFF, 1 ~ 30 s
Initial value: 5 s
(Timer start/lap counting operation)
The switch (LAP STA) preset by function select switch function (See page 82) per-
forms the timer and lap counting operation. Only start can be linked with the throttle
stick.
(Timer stop/reset operation)
The switch (LAP RES) preset by function select switch function (See page 82) per-
forms the timer stop/reset operation. It resets the timer when operated in the timer-
stopped state.
* Timer display
Status display
RST : Reset state
RDY : Throttle stick operation wait
RUN : Timer running
STP : Timer stopped