Galil Motion Control DMC-40 0 Series User Manual

Over-Temperature Protection
The amplifier is also equipped with over-temperature protection.
If the average heat sink temperature rises above 80°C, then the amplifier will be disabled. The over-temperature
condition will trigger the #AMPERR routine if included in the program on the controller.
The amplifier will not be re-enabled until the temperature drops below 80°C and then either an SH command is
sent to the controller, or the controller is reset (RS command or power cycle).
A3 – AMP-43240 (-D3240) ▫ 227 DMC-40x0 User Manual

Galil Motion Control DMC-40 0 Series Specifications

General

Brand	Galil Motion Control
Model	DMC-40 0 Series
Category	Controller
Language	English