The following table describes the information shown when the LCD update is enabled (LU 1):
Axis Status Description
I Idle
i Lower power idle
O Motor Off
M Axis Moving in independent mode
E Position Error exceeded TE > ER
S Stopped from ST command
L Decelerating or stopped by Limit switch
A Stopped by Abort
V Running in Vector or Lienar Interpolation Mode
C Running in Contour Mode
P Running in PVT mode
H Running in a Homing routine
e Running in eCAM mode.
F Amplifier Fault
T Detected
A10 – CMB-41022 (-C022) ▫ 263 DMC-40x0 User Manual
To Next Page
Loading...
