CB 50-100
REV A
GALIL MOTION
CONTROL
MADE IN USA
JC6, JC8 - 50 pin
shrouded headers w/
center key
JC8 - pins 1-50 of J9
JC6 - pins 51-100 of J9
J9
JC6
JC8
1/8"D, 4 places
J9 - 100 pin connector
AMP part # 2-178238-9
(Pin 1)
JC6 (IDC 50 Pin)
Pin1 (2.975", 0.9875" )
JC8 (IDC 50 Pin)
Pin1 (2.975", 0.6125" )
51
52
53
2
1
3
4
DETAIL
Figure A-16
CB-50-80 Adapter Board
The CB-50-80 adapter board can be used to convert the CABLE-80 to (2) 50 Pin Ribbon Cables. The
50 Pin Ribbon Cables provide a versatile method of accessing the extended I/O signals without the use
of the Galil IOM-1964.
The ribbon cables provided by the CB-50-80 are compatible with I/O mounting racks such as Grayhill
70GRCM32-HL and OPTO-22 G4PB24.
When using the OPTO-22 G4PB24 I/O mounting rack, the user will only have access to 48 of the 64
I/O points available on the controller. Block 5 and Block 9 must be configured as inputs and will be
grounded by the I/O rack.
234 • Appendices DMC-2X00
To Next Page
Loading...
