Configuration
G&D DVIMUX2-DL-USB · 20
English
Basic operation of the setup mode as well as the setup menu is explained in the fol-
lowing pages.
All functions that can be configured for the KVM switch are described in detail from
page 23 on.
Operating the setup mode
The setup mode can be enabled using the console keyboard. After enabling, the con-
figuration of the KVM switch can be changed by using various step keys.
How to enable the setup mode:
Press the Hotkey+Backspace (Standard: Ctrl+Backspace) key combination to enable
the setup mode.
How to perform a setup function:
After enabling the setup mode, press one of the setup keys described on the fol-
lowing pages.
How to end the setup mode without performing a function:
Press ESC to end the setup mode.
NOTE:
Only one setup function can be performed after the calling of the setup mode.
If you want to perform more functions, please restart the setup mode.
NOTE:
The successful activation of the setup mode is displayed by the blinking
NUM, and Scroll control LEDs on the keyboard. Additionally, the yellow User
LED will blink at the KVM switch.
IMPORTANT:
The key combination for enabling the setup mode needs to be
pressed for seven seconds.
After the first call of the setup mode, the hotkey delay can be disabled by pressing
the setup key
8 (see page 27).
To Next Page
Loading...
