G&D DVIMUX2-DL-USB - (De)Activating the Switching Via Hotkeys

Configuration
G&D DVIMUX2-DL-USB · 30
English
(De)activating the switching via hotkeys
In the defaults, you can use hotkeys to switch between the computers.
If desired, you can deactivate this kind of switching in the setup menu.
How to enable/disable the switching via hotkeys:
NOTE: Use the setup menu to (de)activate the switching via hotkeys.
Setup Menu
1. Use the terminal emulator to establish a connection to the KVM switch.
If the setup menu is not displayed, the Monitoring mode of the service port is
enabled. Enter
»!« to switch to the setup menu.
2. Use the Arrow or Arrow keys to select the
Select Channel via Hotkey entry.
3. Press the Space key (repeatedly) to choose one of the following options:
Yes  disables the switching via hotkeys
No  enables the switching via hotkeys
4. Press the S key to save your settings.