G&D DVIMUX2-DL-USB - Configuration Settings; Using Single or Double Hotkeys

Configuration
23 · G&D DVIMUX2-DL-USB
Configuration settings
Using single or double hotkeys
If many application programs with key combinations are operated on one computer
or if different G&D devices are used in one cascade, the number of available key
combinations might be restricted.
In such a case, it is appropriate to apply double hotkeys.
How to enable single or double hotkeys:
Depending on your settings, the active hotkey is converted into a double hotkey (or
vice versa):
Setup Mode
1. Press Hotkey+Backspace (default: Ctrl+Backspace) simultaneously to enable
the setup mode.
If the hotkey delay is active, press the key combination for seven seconds.
2. Press one of the setup keys listed below to enable the use of single or double
hotkeys:
S  enables single hotkeys
A  disables double hotkeys
Setup Menu
1. Use the terminal emulator to establish a connection to the KVM switch.
If the setup menu is not displayed, the Monitoring mode of the service port is
enabled. Enter
»!« to switch to the setup menu.
2. Use the Arrow or Arrow keys to select the Double Hotkey entry.
3. Press the Space key (repeatedly) to enable the use of single or double hotkeys:
No  enables single hotkeys
Yes  disables double hotkeys
4. Press the S key to save your settings.
Single Hotkey Double Hotkey
Ctrl Ctrl+Shift
Alt Alt+Shift
Alt Gr Alt Gr+Ctrl
Win Win+Ctrl
Shift Shift+Win