G&D DVIMUX2-DL-USB - Changing the Double Hotkey

Configuration
25 · G&D DVIMUX2-DL-USB
Changing the double hotkey
If the use of double hotkeys is enabled (see page 23), press the double hotkey and the
Backspace key simultaneously to start the setup mode of the KVM switch. Switching
of channels takes place by pressing the double hotkey and a select key at the same
time.
If an application program or another G&D device uses the same hotkey within the
cascade, the hotkey can be changed.
How to change the current double hotkey:
Setup Mode
1. Requirement: enabling of the double hotkeys (see page 23).
2. Press Double hotkey+Backspace (default: Ctrl+Shift+Backspace) simultane-
ously to enable the setup mode.
If the hotkey delay is active, press the key combination for seven seconds.
3. Press one of the setup keys listed below to activate the desired double hotkey:
Ctrl  enables Ctrl+Shift double hotkey
Alt  enables Alt+Shift double hotkey
Alt Gr  enables Alt Gr+Ctrl double hotkey
Win  enables Win+Ctrl double hotkey
Shift  enables Shift+Win double hotkey
Setup Menu
1. Requirement: enabling of the double hotkeys (see page 23).
2. Use the terminal emulator to establish a connection to the KVM switch.
If the setup menu is not displayed, the Monitoring mode of the service port is
enabled. Enter
»!« to switch to the setup menu.
3. Use the Arrow or Arrow keys to select the Hotkey entry.
4. Press the Space key (repeatedly) to enable the desired double hotkey:
Ctrl+Shift  enables Ctrl+Shift double hotkey
Alt+Shift  enables Alt+Shift double hotkey
Alt Gr+Ctrl  enables Alt Gr+Ctrl double hotkey
Win+Ctrl  enables Win+Ctrl double hotkey
Shift+Win  enables Shift+Win double hotkey
5. Press the S key to save your settings.