G&D DVIMUX2-DL-USB - Enabling;Disabling the Hotkey Delay

Configuration
27 · G&D DVIMUX2-DL-USB
Enabling/Disabling the hotkey delay
Press the Hotkey+Backspace (default: Ctrl+Backspace) key combination for seven sec-
onds in order to start the setup mode in the default settings.
You can disable the hotkey delay if you want to start the setup mode immediately
after pressing the key combination.
How to enable/disable the hotkey delay:
Setup Mode
1. Press Hotkey+Backspace (default: Ctrl+Backspace) simultaneously to enable
the setup mode.
If the hotkey delay is active, press the key combination for seven seconds.
2. Press one of the setup keys listed below to enable/disable the hotkey delay:
7  enables hotkey delay
8  disables hotkey delay
Setup Menu
1. Use the terminal emulator to establish a connection to the KVM switch.
If the setup menu is not displayed, the Monitoring mode of the service port is
enabled. Enter
»!« to switch to the setup menu.
2. Use the Arrow or Arrow keys to select the Hotkey Delay entry.
3. Press the Space key (repeatedly) to enable/disable the hotkey delay:
Yes  enables hotkey delay
No  disables hotkey delay
4. Press the S key to save your settings.