Configuration
G&D DVIMUX2-DL-USB · 36
English
Changing the standard mode of the Service port
The Service port of the KVM switch can be used both for operating the setup menu
and for issueing monitoring informations
(see page 16).
The Setup Menu mode is enabled in the default settings of the KVM switch. In this
mode, the Setup Menu is immediately displayed in the terminal emulator after a ses
-
sion is established with the KVM switch.
If you primarily use the Service port for switching the active channel via a serial device,
it is recommendable to enable the
Monitoring mode.
How to choose the mode which is to be enabled when booting the
KVM extender:
IMPORTANT:
Depending on the purpose of use, the KVM extender distinguishes
between the modes listed below.
ADVICE:
The mode that is active when starting the KVM switch can be changed
anytime during operation
by entering the »!« command:
Setup Menu
1. Use the terminal emulator to establish a connection to the KVM switch.
If the setup menu is not displayed, the Monitoring mode of the service port is
enabled. Enter
»!« to switch to the setup menu.
2. Use the Arrow or Arrow keys to select Service Port Config and press Enter.
3. Use the Arrow or Arrow keys to select the row Mode.
4. Press the Space key (repeatedly) to choose between the following options:
Setup Menu use the service port to operate the setup menu
Monitoring use the service port to issue monitoring information
5. After having selected your desired settings, press Q to leave the dialog.
6. Press the S key to save your settings.
To Next Page
Loading...
