G&D DVIMUX2-DL-USB - Changing the Single Hotkey

Configuration
G&D DVIMUX2-DL-USB · 24
English
Changing the single hotkey
Press the hotkey and the Backspace key simultaneously to start the setup mode of the
KVM switch. Pressing the hotkey and the select key simultaneously enables the
switching of channels.
If an application program or another G&D device uses the same hotkey within the
cascade, the hotkey can be changed.
How to change the current hotkey:
NOTE: The single hotkey Ctrl is preset at default.
Setup Mode
1. Press the Hotkey+Backspace (default: Ctrl+Backspace) simultaneously to acti-
vate the setup mode.
If the hotkey delay is active, press the key combination for seven seconds.
2. Press one of the setup keys listed below to enable a certain hotkey:
Ctrl  enables Ctrl hotkey
Alt  enables Alt hotkey
Alt Gr  enables Alt Gr hotkey
Win  enables Win hotkey
Shift  enables Shift hotkey
Setup Menu
1. Use the terminal emulator to establish a connection to the KVM switch.
If the setup menu is not displayed, the Monitoring mode of the service port is
enabled. Enter
»!« to switch to the setup menu.
2. Use the Arrow or Arrow keys to select the Hotkey entry.
3. Press the Space key (repeatedly) to enable a certain hotkey:
Ctrl  enables Ctrl hotkey
Alt  enables Alt hotkey
Alt Gr  enables Alt Gr hotkey
Win  enables Win hotkey
Shift  enables Shift hotkey
4. Press the S key to save your settings.