Configuration
31 · G&D DVIMUX2-DL-USB
(De)activating the switching via step keys
Instead of using hotkeys to switch to one of the channels connected to the KVM
switch, you can also use step keys to switch the channels in ascending or descending
order.
After enabling the step keys, you can use the following key combinations to switch
channels in ascending or descending order:
descending: »back« step key (default: Hotkey+9)
ascending: »forward« step key (default: Hotkey+0)
How to disable/enable the use of step keys:
NOTE:
The use of step keys is disabled in the default settings.
IMPORTANT:
The active step keys are dependent on the selected select keys (see
page 26). The following table lists the step keys depending on the active select keys.
Select keys »Back« step key »Forward« step key
1 ... 2 9 0
NUM 1 ... 2 NUM 9NUM 0
A ... B I K
F1 ... F2 F9 F10
NOTE:
Use the setup menu to enable or disable the usage of step keys.
Setup Menu
1. Use the terminal emulator to establish a connection to the KVM switch.
If the setup menu is not displayed, the Monitoring mode of the service port is
enabled. Enter
»!« to switch to the setup menu.
2. Use the Arrow or Arrow keys to select the Select Channel via Step Key entry.
3. Press the Space key (repeatedly) to choose between the following options:
Off step keys disabled
[Step-Keys] step keys enabled
4. Press the S key to save your settings.
To Next Page
Loading...
