G&D DVIMUX2-DL-USB - Resetting the Defaults

Configuration
G&D DVIMUX2-DL-USB · 28
English
Resetting the defaults
This function resets the default settings of the KVM switch.
How to reset the default settings:
IMPORTANT: Performing this function reactivates the default settings of the KVM
switch as shown on
page 19.
Setup Mode
1. Press Hotkey+Backspace (default: Ctrl+Backspace) simultaneously to enable
the setup mode.
If the hotkey delay is active, press the key combination for seven seconds.
2. Press the setup key listed below to reset the default settings:
D  reset default settings
Setup Menu
1. Use the terminal emulator to establish a connection to the KVM switch.
If the setup menu is not displayed, the Monitoring mode of the service port is
enabled. Enter
»!« to switch to the setup menu.
2. Use the Arrow or Arrow keys to select the Set System Defaults entry.
3. Press Enter to reset the default settings.
4. Confirm the pop up security query with Enter.
Pressing the Q key cancels the function.