Configuration
43 · G&D DVIMUX2-DL-USB
USB pinning
In the default settings of the KVM switch, KVM data and the data of devices con-
nected to the »USB 2.0 Devices« interface are forwarded to the computer of the
active channel.
Enable USB pinning (see page 43) if you want to permanently switch the data of
devices connected to the »USB 2.0 Devices« interface to a defined channel. The per-
manent switching of these devices (see page 15) remains the same even when
switching the KVM channel.
How to enable or disable USB pinning:
HINWEIS:
USB pinning can be enabled or disabled in the setup menu only.
Setup menu
1. Use the terminal emulator to establish a connection to the KVM switch.
If the setup menu is not displayed, the Monitoring mode of the service port is
enabled. Enter
»!« to switch to the setup menu.
2. Use the Arrow or Arrow keys to select the USB Pinning entry and press Enter.
3. Press the Space key (repeatedly) to choose between the following key-
boards:
disabled USB pinning disabled (default)
enabled USB pinning ensabled
4. Press the S key to save your settings.
To Next Page
Loading...
