Page 87
Three Part Sets are available on the GardTec
800
series control panels. Zones
added to the PT-1 (Part 1) screen will be Removed (Omitted) when the system is
Part 1 Set. Zones added to the PT-2 (Part 2) screen will be Removed (Omitted)
when Part Set 2 is used. When Part Set 3 is used Parts 1 & 2 are combined and
Removed (Omitted).
45) If you do not wish to enter PT-1 Zone press Yes
and jump to Step 50.
Otherwise
46) Press No. The display will show:-
47) Enter the Zone number you require for PT-1
followed by Yes.
The display will show for example:-
48) To add more Zones to PT-1 repeat from Step 46.
49) When you have finished adding Zones to PT-1
press Yes.
50) The display will show:-
Pt-2 None
Pt-1 004
Enter Zone # _ _ _
then +YES or -NO
PR5892 Rev11 800 Series Eng Ref 15.qxd 16/11/2006 11:21 Page 87
To Next Page
