Garmin ECHOMAP UHD User Manual

Viewing System Software Information
You can view the software version, the basemap version, all supplemental map information (if applicable), and
the unit ID number. You may need this information to update the system software or to purchase additional map
data information.
Select Settings > System > System Information > Software Information.
Viewing E-label Regulatory and Compliance Information
The label for this device is provided electronically. The e-label may provide regulatory information, such as
identification numbers provided by the FCC or regional compliance markings, as well as applicable product and
licensing information. Not available on all models.
1 Select Settings.
2 Select System.
3 Select Regulatory Information.
My Vessel Settings
NOTE: Some settings and options require additional charts or hardware.
Select Settings > My Vessel.
Keel Offset: Offsets the surface reading for the depth of a keel, making it possible to measure depth from the
bottom of the keel instead of from the transducer location (Setting the Keel Offset, page45).
Temp. Offset: Compensates for the water temperature reading from a NMEA 0183 water-temperature sensor or
a temperature-capable transducer (Setting the Water Temperature Offset, page103).
Vessel Type: Enables some chartplotter features based on the boat type.
Fuel Capacity: Sets the combined fuel capacity of all the fuel tanks on your vessel (Setting the Fuel Capacity of
the Vessel, page85).
Fill Up All Tanks: Sets the tank levels to full (Synchronizing the Fuel Data with the Actual Vessel Fuel, page85).
Add Fuel to Boat: Allows you to enter the quantity of fuel you added to your tank, when you did not entirely fill up
the tank (Synchronizing the Fuel Data with the Actual Vessel Fuel, page85).
Set Total Fuel Onboard: Sets the combined amount of fuel in all the fuel tanks on your vessel (Synchronizing the
Fuel Data with the Actual Vessel Fuel, page85).
Set Gauge Limits: Sets the upper and lower limits of various gauges (Customizing Engine Gauge and Fuel Gauge
Limits, page86).
CZone™: Sets the digital switching circuits.
SeaStar Instance: Sets the digital switching circuits.
Hull ID: Allows you to enter the Hull Identification Number (HIN).The HIN might be permanently affixed to the
upper starboard side of the transom or outboard side.
Device Configuration 101

Garmin ECHOMAP UHD Specifications

General

Water Rating	IPX7
Routes	100
Sonar	Yes (CHIRP, ClearVü, SideVü)
GPS	Yes
Preloaded Maps	Yes
Network Support	Yes, Garmin Marine Network
Wi-Fi	Yes
Mounting Options	Flush mount
Antenna	Internal
Transmitter Power	500W (RMS), 4000W (peak to peak)
Sonar Frequencies Supported	ClearVü/SideVü: 260/455/800 kHz
Maximum Depth	2, 300 ft (freshwater)
Wireless Connectivity	Wi-Fi