86
Edge
®
820
TH
if audible tones are turned on
(Turning the Device Tones On and Off, page
91)
.
Auto Lap
Marking Laps by Position
You can use the Auto Lap feature to mark the lap at a specific position
automatically. This feature is helpful for comparing your performance over
different parts of a ride (for example, a long climb or training sprints). During
courses, you can use the By Position option to trigger laps at all of the lap
positions saved in the course.
1 Select
> Settings > Activity Profiles.
2 Select a profile.
3 Select Auto Lap > Auto Lap Trigger > By Position > Lap At.
4 Select an option:
• Select Lap Press Only to trigger the lap counter each time you select
and each time you pass any of those locations again.
• Select Start and Lap to trigger the lap counter at the GPS location where
you select
and at any location during the ride where you select
.
• Select Mark and Lap to trigger the lap counter at a specific GPS location
marked before the ride and at any location during the ride where you
select
.
5 If necessary, customize the lap data fields
(Customizing the Data Screens,
page 83)
.
Edge 820_SEA英泰印 [4.75x4.75]-7.indd 86 2016/8/27 下午 03:01:35
To Next Page
