Replying to an inReach Message
You can reply to an inReach message with a pre-written message.
1 From the InReach® page, select Messages.
A list of sent and received messages appears.
2 Select a received message.
3 Select Reply.
4 Select a message.
5 Select Send.
Digital Switching
Your chartplotter can be used to monitor and control circuits when connected to a compatible digital switching
system.
For example, you can control the interior lights and navigation lights on the vessel. You can also monitor live
well circuits.
To access the digital switching controls, select Vessel > Switching.
For more information about purchasing and configuring a digital switching system, contact your Garmin dealer.
Adding and Editing a Digital Switching Page
You can add and customize digital switching pages to the chartplotter.
1 Select Vessel > Switching > Options > Setup.
2 Select Add Page or Edit Page.
3 Set up the page as needed:
• To enter a name for the page, select Name.
• To set up the switches, select Edit Switches.
• To add an image of the boat, select Add BoatView Image.
NOTE: You can load an image of your vessel into the device to use for the image, or use a default image.
You can also adjust the view and placement of the image.
Dometic
®
Optimus
®
Features
When connected to a compatible Optimus system, the chartplotter allows you to access and control the system.
You can enable the Optimus overlay to control the Optimus system (Activating the Optimus Overlay Bar,
page 130).
When necessary, the Optimus system provides messages with information, instructions, and alerts about faults
and hazards.
A no swimming icon indicates that you should not swim when certain Optimus modes are active. In these
modes, propeller control is automatic and could injure someone in the water.
Activating the Optimus Overlay Bar
1 From a chart, select Options > Edit Overlays.
2 Select Top Bar or Bottom Bar.
3 Select Optimus Bar.
130 Digital Switching
To Next Page