Controlling a Computer with the Chartplotter
Before you can control a computer using the chartplotter, you must connect the chartplotter and computer
correctly. See the chartplotter installation instructions for connection information.
1 Select Vessel > Video.
2 Select the HDMI source for the computer.
3 Select Options > USB Touch Out.
You can now control your computer using two-finger touch gestures on the chartplotter screen.
4 If necessary, select Options > Full Screen to view the computer screen in full screen mode.
TIP: To exit full screen mode, press .
Pairing the GRID Device with the Chartplotter from the Chartplotter
NOTE: These steps are applicable to both the GRID device and the GRID 20 device.
Before you can pair the GRID 20 device with the chartplotter to make the data connection, you must supply
power using batteries, the included power cable, or a NMEA 2000 network connection.
Before you can pair the GRID device with the chartplotter, you must connect it to the Garmin Marine Network.
1 Select Options > Settings > System > Station Information > GRID™ Pairing > Add.
2 Select an action:
• On the GRID remote input device, press SELECT.
• On the GRID 20 remote input device, press and until the remote control beeps three times.
Pairing the GRID Device with the Chartplotter from the GRID Device
NOTE: This is not applicable to the GRID 20 device.
1 On the GRID remote input device, press + and HOME at the same time.
A selection page opens on all of the chartplotters on the Garmin Marine Network.
2 Rotate the wheel on the GRID remote input device to highlight Select on the chartplotter you want to control
with the GRID remote input device.
3 Press SELECT.
Rotating the GRID Remote Input Device
For certain installation situations, you can rotate the orientation of the GRID device.
NOTE: This is not applicable to the GRID 20 device.
1 Select Options > Settings > Communications > Marine Network.
2 Select the GRID device.
Cleaning the Screen
NOTICE
Cleaners containing ammonia will harm the anti-reflective coating.
The device is coated with a special anti-reflective coating which is very sensitive to waxes and abrasive
cleaners.
1 Apply an eyeglass lens cleaner specified as safe for anti-reflective coatings to the cloth.
2 Gently wipe the screen with a soft, clean, lint-free cloth.
178 Appendix
To Next Page