Marine Network
The Marine Network allows you to share data from Garmin peripheral devices with the chartplotters quickly and
easily. You can connect a chartplotter to the Marine Network to receive data from and share data with other
devices and chartplotters that are compatible with the Marine Network.
Select Options > Settings > Communications > Marine Network.
Setting Alarms
CAUTION
The Beeper setting must be turned on to make alarms audible (Sounds and Display Settings, page 156). Failure
to set audible alarms could lead to injury or property damage.
Navigation Alarms
Select Options > Settings > Alarms > Navigation.
Arrival: Sets an alarm to sound when you are within a specified distance or time from a turn or a destination.
Anchor Drag: Sets an alarm to sound when you exceed a specified drift distance while anchored.
Off Course: Sets an alarm to sound when you are off course by a specified distance.
Boundary Alarms: Disables and enables all boundary alarms.
Setting the Anchor Drag Alarm
You can set an alarm to sound if you have moved more than an allowable distance. This is very useful when
anchoring overnight.
1 Select Options > Settings > Alarms > Navigation > Anchor Drag.
2 Select Alarm to turn on the alarm.
3 Select Set Radius, and select a distance on the chart.
4 Select Back.
System Alarms
Select Options > Settings > Alarms > System.
Clock: Sets an alarm clock.
Unit Voltage: Sets an alarm to sound when the battery reaches a specified low voltage.
GPS Accuracy: Sets an alarm to sound when the GPS location accuracy falls outside the user-defined value.
162 Device Configuration
To Next Page