Networked Video Devices
NOTICE
A Garmin Power over Ethernet (PoE) Isolation Coupler (P/N 010-10580-10) must be used when connecting
Ethernet devices, such as FLIR
®
cameras, to a Garmin Marine Network. Connecting an Ethernet device directly to
a Garmin Marine Network chartplotter damages the Garmin chartplotter and may damage the Ethernet device.
Before you can view and control video devices such as IP cameras, encoders, and thermal cameras using your
chartplotter, you must have a compatible video device connected to your chartplotter, and you must have a
marine network cable Power over Ethernet (PoE) isolation coupler. Go to garmin.com for a list of compatible
devices or to purchase a PoE Isolation Coupler.
You can connect multiple supported video cameras and up to two video encoders to the Garmin Marine
Network. You can select and view up to four video sources at once. Chartplotters with multiple composite built-
in video inputs can display a single built-in video input only. When the cameras are connected, the network
detects them automatically and displays them in the source list.
Using Video Presets on Networked Video Cameras
You can save, name, and activate video presets for each networked video source.
Saving Video Presets on a Networked Video Camera
1 From a video screen, touch the screen.
The video controls appear on the screen.
2 Hold a video preset button.
A green light indicates the setting is stored.
Naming Video Presets on a Networked Video Camera
1 From a video screen, select Options > Video Setup > Presets.
2 Select a preset.
3 Select Rename.
4 Enter preset name.
Activating Video Presets on a Networked Video Camera
You can quickly return networked cameras to preset values.
1 From a video screen, touch the screen.
The video controls appear on the screen.
2 Select a video preset.
The camera restores the video settings saved for that preset.
TIP: You can also save and activate presets using the video menu.
Camera Settings
Some cameras provide additional options to control the camera view.
NOTE: Not all options are available on all camera models and chartplotter models. Refer to the camera manual
for a list of available features. You may need to update the camera software to use this feature.
From the infrared video screen, select Options.
IR Blend: Selects the infrared effect to MSX
®
(Multi-Spectral Dynamic Imaging) mode or CTV (Color Thermal
Vision
™
) mode, and allows you to blend the effects.
IR/Visible: Displays an infrared or visible light image.
Scan: Surveys the surrounding area.
Freeze: Pauses the camera image.
Change Colors: Selects the color scheme of the infrared image.
Change Scene: Selects the infrared image mode, such as day, night, MOB, or docking.
Video Setup: Opens more video options.
146 Viewing Video
To Next Page