Setting a Song to Repeat
1 While playing a song, select Options > Repeat.
2 If necessary, select Single.
Setting All Songs to Repeat
From the media screen, select Options > Repeat > All.
Setting Songs to Shuffle
1 From the media screen, select Options > Shuffle.
2 If necessary, select an option.
Joining the Fusion PartyBus
™
Network
You can play music from other compatible stereos connected to the Fusion PartyBus network. One Fusion
PartyBus stereo must be connected to the chartplotter using the NMEA 2000 network.
NOTE: A Fusion PartyBus zone stereo, such as the Apollo
™
SRX400 zone stereo, cannot stream sources to other
Fusion PartyBus devices on the network. Because of this, zone stereos do not appear as available sources in
the chartplotter.
1 From the media screen, select Source.
NOTE: After few moments, the compatible Fusion PartyBus stereos appear as sources.
2 Select the Fusion PartyBus stereo.
3 If necessary, select Source, and select a different source connected to the Fusion PartyBus stereo.
To leave the Fusion PartyBus network, you can select Source > Leave PartyBus.
Adjusting the Volume
Muting the Media Volume
1 From the media screen, select .
2 If necessary, select Select.
Enabling and Disabling Zones
If you have wired your vessel's speakers into zones, you can enable needed zones and disable unused zones.
1 From the media screen, select Options > Audio Levels > Enable/Disable Zones.
2 Select a zone.
VHF Radio
NOTE: These features are available on some stereos with a VHF receiver.
Scanning VHF Channels
Before you can scan VHF channels, you must set the source to VHF.
You can monitor VHF channels saved as presets for activity and automatically switch to an active channel.
From the VHF media screen, select Options > Scan.
Adjusting the VHF Squelch
NOTE: This feature is available on some stereos with a VHF receiver.
1 From the VHF source page, select Options > Squelch.
2 Use the slider bar to adjust the VHF squelch.
Media Player 135
To Next Page