EasyManua.ls Logo

GE 750 - Page 393

GE 750
504 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GE Power Management 750/760 Feeder Management Relay 16-
85
16 COMMUNICATIONS 16.5 DNP 3.0 DEVICE PROFILE
16
1.
The data link layer confirmation mode, confirmation timeout and number of retries are all configurable. Refer to the set-
points defined under
S1 RELAY SETUP / COMMUNICATIONS / DNP
for more details. Additional setpoints related to DNP
are discussed in Section 8.3: DNP COMMUNICATIONS on page 8–3.
Executes Control Operations:
WRITE Binary Outputs Never
p
Always
p
Sometimes
p
Configurable
SELECT/OPERATE
p
Never Always
p
Sometimes
p
Configurable
DIRECT OPERATE
p
Never Always
p
Sometimes
p
Configurable
DIRECT OPERATE - NO ACK
p
Never Always
p
Sometimes
p
Configurable
Count > 1 Never
p
Always
p
Sometimes
p
Configurable
Pulse On
p
Never
p
Always Sometimes
p
Configurable
Pulse Off Never
p
Always
p
Sometimes
p
Configurable
Latch On
p
Never
p
Always Sometimes
p
Configurable
Latch Off
p
Never
p
Always Sometimes
p
Configurable
Trip/Close
p
Never
p
Always Sometimes
p
Configurable
(For an explanation of the above, refer to the discussion accompanying the point list for the Binary Output/
Control Relay Output Block objects)
Queue Never
p
Always
p
Sometimes
p
Configurable
Clear Queue Never
p
Always
p
Sometimes
p
Configurable
Reports Binary Input Change Events when no
specific variations requested:
p
Never
Only time-tagged
p
Only non-time-tagged
p
Configurable to send both, one or the other
Reports time-tagged Binary Input Change Events
when no specific variation requested:
p
Never
Binary Input Change With Time
p
Binary Input Change With Relative Time
p
Configurable
Sends Unsolicited Responses:
Never
p
Configurable
p
Only certain objects
p
Sometimes
p
ENABLE/DISABLE UNSOLICITED
Function codes supported
Sends Static Data in Unsolicited Responses:
Never
p
When Device Restarts
p
When Status Flags Change
Default Counter Object/Variation:
No Counters Reported
p
Configurable
p
Default Object
Default Variation
p
Point-by-point list attached
Counters Roll Over at:
No Counters Reported
p
Configurable
p
16 Bits
p
32 Bits
p
Other Value
p
Point-by-point list attached
Sends Multi-Fragment Responses:
p
Yes No
DNP 3.0
DEVICE PROFILE DOCUMENT (Continued)
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S

Table of Contents

Other manuals for GE 750

Related product manuals