Service interfaces
2001989-203C ApexPro™ Telemetry 4-9
Configuration tab
The following links are found on the Configuration tab.
Link name Description
System Information Used to display the following links:
Software Version, used to display the following information:
Clinical, service and operating system active and inactive versions
ATS status
System Information, used to change the ATS serial number. See Enter the ATS serial number on page
4-12.
Customer Asset, used to edit customer asset and contact information.
Logout Used to log user out of Webmin.
Link name Description
ATS Control Used to start, stop, and restart the ATS software and operating system remotely. See Safe shutdown/restart of
the ATS on page 6-21.
Backup/Restore Used to back up and restore critical ATS configuration information. See Back up the configuration settings on
page 5-15.
Device Master Used for ATS configuration setting (determines type of Telemetry System). See Enable access points for
activity on the network on page 5-22.
Passwords Used to change the password for the biomed user only. See Change password for biomed user on page 4-11.
Receiver Configuration Used to add, change and delete a group of receivers allocated to a telemetry tower. See Configure the
receivers on page 5-8.
Remote Service Used to configure the following information:
Remote service configuration, used to configure remote connection parameters. See Configure the
server for Remote Service access on page 5-10.
Remote service controls, used to do the following:
Enable the service to have it actively run or to restart it.
Disable the service to prevent the service from running, even after a reboot.
See Enable the Remote Service agent on page 5-12.
Settings Used to configure the following settings:
ApexPro, including the computer language, clinical application mode (Rack or VTOR), the tower name,
the unit name, the A/C power frequency, designation of device master, print discharge report option, and
localization information. See Set the ApexPro Channelized Telemetry System settings on page 5-6 and
Set the ApexPro FH Telemetry System settings on page 5-18.
Network, including the computer network name and the IX, MC and RX network addresses, including
DNS address information. See Set the ApexPro Channelized Telemetry System network name and IP
address on page 5-4 and Set the ApexPro FH Telemetry System network name and IP address on page
5-20.
Software Management Used to view active and inactive software packages installed on the system. See Upgrading ATS software on
page B-1.
Logout Used to log user out of Webmin.
To Next Page
Loading...
Need help?
General
