GE Discovery NM/CT 670 - Page 80

Equipment Description and General Construction Requirements 2.3 Room Structural Requirements
2.3.1 Floor Requirements
Discovery NM/CT 670 – Standard Integration Instructions
5483063-1EN, Rev.2, ©2015 GE Healthcare 2-37
9 -980.00 835.65
102.0
CT Short
Plate
Main Anchor
HILTI
HSL-3
M10/20
35 Figure 2-3
10 -980.00 630.65
11 -1495.00 630.65
12 -1495.00 855.65 Alternative Anchor
13 -1880.00 -630.65
CT Long
Plate
Main Anchor
14 -1495.00 -630.65
15 -980.00 -830.65
16 -980.00 -855.65
17 -1495.00 -855.65 Alternative Anchor
18 -1965.00 -855.65 Main Anchor
19 -2055.00 966.85
CT Service
Plate -1
Main Anchor
20 -2545.00 891.85
21 -2065.00 891.85
Alternative Anchor
22 -2545.00 966.85
23 -2545.00 -891.85
CT Service
Plate -2
Main Anchor
24 -2065.00 -966.85
25 -2065.00 -891.85
Alternative Anchor
26 -2545.0 -966.85
27 -1703.50 72.50
Bearing Plate
of Service
Lead Screw
Main Anchor
During
Lead
Screw
Installation
28 -1623.50 -72.50
29 -1623.50 72.50
Alternative Anchor
30 -1703.50 -72.50
31 -349.00 63.50
Gear Bracket
of Service
Lead Screw
Main Anchor
32 -279.00 -63.50
33 -279.00 63.50
Alternative Anchor
34 -349.00 -63.50
Table 2-3: D670 Drilling and Anchor Chart(Continued)
No. X Y
Drill
Hole
Hole
Depth
Anchored
Part
Hole Purpose
Drilling
Method
Anchor
Type
Torque
Nm.
Section