D-4 F35 MULTIPLE FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL
REVISION HISTORY APPENDIX D: MISCELLANEOUS
D
--- Added Phase Overvoltage content to product description, specifications, FlexLogic operands table, settings, features per
product table, Modbus memory map, IMD table
--- Updated number of Breaker Restrike elements, increasing from three to six, in FlexLogic operands table, settings, features per
product table, Modbus memory map
--- Added Cold Load Pickup content to product description, FlexLogic operands table, settings, features per product table,
Modbus memory map, IMD table
--- Added Breaker Flashover content to product description, specifications, FlexLogic operands table, settings, features per
product table, Modbus memory map, IMD table
2- Updated several specifications, such as TOC, IOC, number of FlexLogic lines
4-30 Added FlexLogic Design and Monitoring using Engineer section to end of Interfaces chapter
5-38 Added PRT FUNCTION settings in Network section to enable/disable each Ethernet port
5-49 Updated IEC 61850 section
5-61 Added Support for Routable GOOSE section
5-169 Updated number of FlexLogic lines from 512 to 1024 in FlexLogic Equation Editor settings section
10-1 Added Monitoring section
10-2 Added Retrieve Files section
C- Added Command Line Interface appendix
Page Description
To Next Page
Loading...
