GEK-113000AE F650 Digital Bay Controller 5-5
5 BOOTCODE AND FIRMWARE UPGRADE 5.1 UPGRADE FROM VERSION BELOW V7.00.
5
9. A warning messages will appear by clicking "UPGRADE FILE"
Figure 5–5: WARNING MESSAGE BEFORE BOOT CODE UPGRADE
If calibration files were saved click Yes, otherwise click No to cancel the upgrade process and save first the calibration files
according to manual section 4.1.11.
Figure 5–6: WARNING MESSAGE TO SAVE SETTING AND CONFIGURE FILES
10. Parameters already set in step 5 will be operative during serial communications. If they have not been previously set a
pop up window will come up, asking for serial COM port to be used during upgrading.
Figure 5–7: SET RELAY IP ADDRESS
11. .During the upgrade, the system will show the following message indicating the procedure to be followed.
To Next Page
Loading...
