EasyManuals Logo

GE F650 User Guide

GE F650
323 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
GEK-113000AE F650 Digital Bay Controller 2-31
2 PRODUCT DESCRIPTION 2.5 TECHNICAL SPECIFICATIONS
2
Protocols available:
ModBus
®
RTU / DNP 3.0/IEC103
Typical distance:
1200 m for cooper cable, 1000 m for glass fiber and 50 m for
plastic fiber
Isolation: 2 kV
CAN PORT:
Rear port: CAN port in models C, M, X, Y, Z for asynchronous rear ports
Type: Multimode glass F.O. port with ST connectors
Fiber Wave length: 820 nm
Fiber type:
multimode 62.5/125 ÎĽm or 50/125 ÎĽm
Maximum recommended length
300m for cooper cable and glass fiber
Isolation: 2 kV
ETHERNET PORT:
Rear port:
For models B, C, D, E
ETH_1/ ETH_2
For models G,H,J,K,L,M
ETH_E/ ETH_A/ ETH_B
Type (depending on model):
Model B:
10/100BaseTX self-negotiable
Model C:
10/100BaseTX + 100Base FX
Model D:
10/100BaseTX + redundant 100BaseFX (Physical media redundancy)
Model E:
Redundant 10/100BaseTX self-negotiable ports
Model G:
1588, 10/100 Base TX* + 100 Base TX
Model H:
1588, 10/100 Base TX* + 100 Base FX
Model J:
PRP, 1588, 10/100 Base TX* + Redundant 100 Base FX
Model K:
PRP, HSR, RSTP, 1588, 10/100 Base TX* + Redundant 100 Base FX
Model L:
PRP, 1588, 10/100 Base TX* + Redundant 100 Base TX
Model M:
PRP, HSR, RSTP, 1588, 10/100 Base TX* + Redundant 100 Base TX
NOTE: (*) This Ethernet port (ETH_E) is intended only for maintenance purpose.
10/100BaseTX
RJ45 connector
100BaseFX
ST connectors
Wave length:
1300 nm
Fiber type:
multimode 62.5/125 . m or 50/125 . m
Protocols available:
ModBus® TCP/IP
DNP over TCP/IP and UDP/IP
IEC 61850
Http, ftp, tftp (allow the use of a standard Internet browser)
Typical distance:
1000 m for glass fiber and 150 m for RJ45 cable
Response time to ModBus commands: 10 ms Typical
Isolation: 2 kV
In Models C and D, the 10/100BaseTX port is selected by an internal switch (see 3.3.3)
Two witness LED’s for transmission and reception are included
SIMPLE NETWORK TIME PROTOCOL (SNTP)
Clock synchronization error: <10 ms (typical)
PRECISION TIME PROTOCOL (PTP)
PTP IEEE Std 1588 2008 (version 2)
Power Profile (PP) per IEEE Standard PC37.238TM2011
Slave-only ordinary clock

Table of Contents

Other manuals for GE F650

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE F650 and is the answer not in the manual?

GE F650 Specifications

General IconGeneral
ModelF650
CategoryController
Frequency50/60 Hz
DisplayLCD
TypeFeeder Protection Relay
ApplicationFeeder Protection and Control
Communication ProtocolsDNP3, Modbus, IEC 61850
Protection FunctionsOvercurrent, Earth Fault
ManufacturerGeneral Electric
Input Voltage24-250 VDC/VAC

Related product manuals