GE Healthcare Brivo XR118 - Page 150

GE HEALTHCARE
DIRECTION 5461425-8EN, REVISION 6 BRIVO XR118 SERVICE MANUAL
Page 150 Section 10.0 - PACS / Image Display Test Image
i.) Highlight PACS Test Image 6 in the Images list
ii.) Click the appropriate PACS Network Host in the Destination icon list
f.) Review images on PACS
i.) Bring PACS Test Images 1 and 6 up on the PACS review workstation.
• The images can be identified by the watermark image number next to the GE
logo inside the chest image region.
• Verify (if possible) that Image 1 is displayed with a VOI-LUT, and Image #6
is displayed with a Linear LUT
ii.) If PACS Test Images 1 and 6 appear visually identical (equal number of bright/
dark bands), the PACS supports VOI-LUT. **: Configure PACS as No-Burn
iii.) If PACS Test Images 1 and 6 appear visually different (different number of bright/
dark bands), or chest region has saturation in lung or abdomen, the PACS either
does not support VOI-LU or applies it incorrectly. **: Configure PACS as Burn-on-
Send
iv.) Record results in Table 6-2, line numbers 3 and 4
** For more information, see Background and In-Depth Instructions below.
3.) Suggested Configurations
Table 6-1 should be used as a guideline in addition to the tests above to determine if a PACS
system should be configured for Burn-on-Send. This table considers only whether a PACS
supports VOI-LUTs.
Table 6-1 Suggested PACS Configurations
No-Burn Burn-on-Send
GE Centricity RA1000 v1.0,v2.0, v2.1 GE Pathspeed v7.12, 8.0
GE Centricity RA600 v6.1, 7.0
GE AW v3.1, 4.0
GE Radworks v5.1
Kodak DirectView v4.3
GE Pathspeed v8.1 or later
Kodak DirectView v5.1, 5.2
McKesson HRS v3.3, 3.3.2
Kodak Directview(CEMAX ICON), v4.3
Fuji Synapse v3.0, 3.1
Merge eFilm, v2.0, 2.1.0
Agfa IMPAX v4.5, 5.2
Stentor iSite v3.0, v3.3.1
Philips
Siemens Magic View 300
RealTime iPACS Viewer v5.0
VA Vista