GE Healthcare Brivo XR118 - Page 156

GE HEALTHCARE
DIRECTION 5461425-8EN, REVISION 6 BRIVO XR118 SERVICE MANUAL
Page 156 Section 10.0 - PACS / Image Display Test Image
on PACS through either a menu drop down, a button, or right-clicking the
image. Click something indicating “ information ”, “ i ”, or “ header ”. Contact
local IT support for further information.
b.) No-Burn Mode (PACS Test Image 1)
i.) Window Center/Width
• Window Center and Window Width tags are 0028x1050 and 0028x1051
• There should be three values separated by a “/”.
• The values should be WC=5226/5226/5226 and WW=2654/1990/3981.
ii.) VOI-LUT Tags
• Search the DICOM header for tag 0028x3010 VOILUTSequence.
• Below this tag there should be three items 1, 2, and 3 which each have the
following 3 tags: 0028x3002LUTDescriptor, 0028x3003LUTExplanation, and
0028x3006LUTData.
• Each VOILUTSequence should have a LUTExplanation as either Normal,
Harder, or Softer.
iii.) Record results in Step , Line number 5
c.) Burn-on-Send Mode (PACS Test Image 6)
i.) Window Center/Width
• Window Center and Window Width tags are 0028x1050 and 0028x1051
• There should be three values separated by a “/”.
• The values should be WC=8192/8192/8192 and WW=16383/12288/24575.
ii.) VOI-LUT Tags
• Search the DICOM header for tag 0028x3010 VOILUTSequence.
• No VOILUTSequence tag should be present. If a VOILUTSequence is
present, the image was not sent correctly. Resend the image as Burn-on-
Send.
iii.) Record results in Table 6-2, Line number 6