GE HEALTHCARE OPTIMA XR200AMX/XR220AMX
D
IRECTION 5336113-1EN, REVISION 10 INSTALLATION MANUAL
Chapter 4 Configuration Page 101
instructions to change the default internal IP Address if an IP Address conflict occurs with the
hospital network.
Note: To change IP address or configure the snapshot tool, you need the Account and Password
information. Please consult your administrator for them.
1. Plug in the Service Keyboard.
2. Open a terminal window using CTRL+SHIFT+F5
and click on the terminal window icon.
3. Change users by entering the account and password at the prompt:
Note: Please consult your administrator for the Account and Password information.
su
#superxr
4. Run the Change IP script by entering the following text at the prompt:
/magichome/xruser/engg/changeIp.sh
5. Select 1 of the 5 options of subnet IP addresses. Write down the IP Address you select, you
will need this in a later step.
1. 172.16.x.x
2. 172.17.x.x
3. 172.18.x.x
4. 192.168.x.x (SW LFC default)
5. 192.169.x.x
6. The PC will reboot automatically, select SHUTDOWN
when the system presents the Degraded
mode screen.
7. Login to system.
8. Open a terminal window and become root.
Note: Please consult your administrator for the Account and Password information.
xruser@magic: su
Password: #superxr
At prompt, type: ifconfig | more
Confirm the br0 IP Address is XXX.XXX.3.1 (where XXX.XXX equals the address range
selected above).
9. To test network connectivity, perform a C-Echo test to one or more of the Network Hosts.
10. This step applies to Optima XR220amx or Optima XR200amx with Digital Upgrade only.
Verify that all connected detectors boot successfully. Verify that you can take an exposure on
all available receptors.
11. This step applies to Optima XR220amx or Optima XR200amx with Digital Upgrade only.
Verify the Detector Wireless connection is active by acquiring an image.
12. Perform the Snapshot Tool Configuration.
4.13.1 Snapshot Tool Configuration
To ensure that the Auto-Snapshot Tool works after changing the IP Address.
1. Open a terminal window using CTRL+SHIFT+F5
and click on the terminal window icon.
2. Switch to root by entering the following text at the prompt:
Note: Please consult your administrator for the Account and Password information.
su
To Next Page
Loading...
