GE HEALTHCARE OPTIMA XR200AMX/XR220AMX
D
IRECTION 5336113-1EN, REVISION 10 INSTALLATION MANUAL
Chapter 3 Installation Page 33
Chapter 3 Installation
Section 3.1 Installation process
1. Unpack the system (Section 3.2 Unpacking the system on page 34).
2. Replace the electrical plug, if necessary (Section 3.3 Replacing the electrical plug on
page 35).
3. Perform leakage and ground testing as required (Section 3.5 Ground and leakage testing on
page 37).
4. Power on and plug in the system (Section 3.4 Turning on the system on page 35).
5. Install the digital detector (Section 3.6 Installing the digital detector on page 50) (Optima
XR220amx only).
6. Install hardware options, such as the DAP meter or barcode reader (Section 4.10 Installing
hardware options on page 74).
7. Apply local language labels (Section 3.7 Applying local language labels on page 56).
See Figure 3-1 for the installation workflow.
After installation, configure the system according to the site’s requirements, as described in Chapter
4 Configuration. Perform necessary calibration, as described in Chapter 5 Calibration.
To Next Page
Loading...
