GE Healthcare Optima XR200amx - Troubleshooting Connections

GE HEALTHCARE OPTIMA XR200AMX/XR220AMX
D
IRECTION 5336113-1EN, REVISION 10 INSTALLATION MANUAL
Chapter 4 Configuration Page 63
Some fields are auto-populated. Depending on the type of authentication, complete the other
required information, as described in the table below:
5. Click ADD
.
6. Select the Networks tab, and verify that the network is listed.
7. Select the Current Status tab, and click CONNECT
. Verify successful connection message.
8. To verify connectivity:
a. Select FILE > TOOLS.
b. Enter the IP of the machine you want to ping.
c. Press START PING
and check for messages verifying connectivity.
d. Press STOP PING
.
4.2.6.4 Troubleshooting connections
If you try to connect in an enterprise situation, it will continue to try to connect until you tell it to stop
by selecting DISCONNECT
.
Table 4-8
Authentication type Required fields No FIPS FIPS ON
Static WEP (Shared Key
authentication)
• WEP keys Y N
WPA
TM
-Personal (PSK)
• Encryption (if different than TKIP)
• PSK
Y N
WPA
TM
-Enterprise (EAP)
• Encryption (if different than TKIP)
• Identity
• Password
• Client certificate
• Inner Auth
• Private key file
• Private key password
• PEAP version (only if EAP method is set to PEAP)
Y N
WPA2
TM
-Personal (PSK)
• Encryption (if different than TKIP)
• PSK
Y Y
WPA2
TM
-Enterprise (EAP)
• Encryption (if different than CCMP)
• Identity
• Password
• Client certificate
• Inner Auth
• Private key file
• Private key password
• PEAP version (only if EAP method is set to PEAP)
Y N
WPA2
TM
-Enterprise (EAP)
• EAP-TLS
N Y