GE Healthcare Optima XR200amx - Configuring Non-Broadcast SSID Networks

GE HEALTHCARE OPTIMA XR200AMX/XR220AMX
D
IRECTION 5336113-1EN, REVISION 10 INSTALLATION MANUAL
Page 62 Section 4.2 Using the System Configuration Tool (SUIF)
6. Click ADD.
7. Select the Current Status tab, and click CONNECT
. Verify successful connection message.
8. To verify connectivity:
a. Select FILE menu > TOOLS.
b. Enter the IP of the machine you want to ping.
c. Press START PING
and check for messages verifying connectivity.
d. Press STOP PING
.
4.2.6.3 Configuring non-broadcast SSID networks
1. On the Wireless configuration screen, select NETWORK menu > ADD.
2. Select IP settings:
- If the system will be identified on the network by a static IP address, select STATIC IP
,
and enter the IP address, netmask, and gateway. If no gateway is used, you must enter
0.0.0.0.
- If the system will be identified on the network using DHCP, select DHCP
.
3. Enter the network SSID.
4. Choose the authentication type.
WPA
TM
-Enterprise (EAP)
• Encryption (if different than TKIP)
• Identity
• Password
• Client certificate
• Inner Auth
• Private key file
• Private key password
• PEAP version (only if EAP method is set to PEAP)
Y N
WPA2
TM
-Personal (PSK)
• Encryption (if different than TKIP)
• PSK
Y Y
WPA2
TM
-Enterprise (EAP)
• Encryption (if different than CCMP)
• Identity
• Password
• Client certificate
• Inner Auth
• Private key file
• Private key password
• PEAP version (only if EAP method is set to PEAP)
Y N
WPA2
TM
-Enterprise (EAP)
• EAP-TLS
N Y
Table 4-7
Authentication type Required fields No FIPS FIPS ON