GE HEALTHCARE OPTIMA XR200AMX/XR220AMX
D
IRECTION 5336113-1EN, REVISION 10 INSTALLATION MANUAL
Chapter 4 Configuration Page 59
4.2.2 Networking configuration
The following information can be viewed regardless of service mode.
4.2.3 General configuration
If the site is using a master time server (see 4.2.10 Time Server configuration on page 66), some
settings in this section are superceded by the master clock server data.
Table 4-3 Networking tab parameters
Parameter Definition
DHCP Configuration
Options: DHCP or Static.
Determines whether the IP address is assigned, or acquired
dynamically. If Static is selected, enter associated information in IP
Address, Subnet Mask, and DNS fields.
IP Address Fixed Only
System IP address.
Enabled only if Wired IP Settings is set to Static.
Subnet Mask Fixed Only
System subnet mask.
Enabled only if Wired IP Settings is set to Static.
Default Gateway Fixed Only
Default gateway.
Enabled only if Wired IP Settings is set to Static.
Static DNS Server 1
Site domain name server.
Enabled only if Wired IP Settings is set to Static.
Static DNS Server 2
Site domain name server.
Enabled only if Wired IP Settings is set to Static.
AE Title Fixed Only
Application Entity Title for DICOM.
Fixed value.
Port Number Fixed Only
Software port used for network communications.
Fixed value.
Table 4-4 General tab parameters
Parameter Definition
Timezone Time zone of site where system is installed.
System Clock System time in YYYYMMDD HH:MM:SS format.
Date Display Format MM-DD-YYYY or DD-MM-YYYY.
Time Display Format Military (24-hour) or AM/PM (12-hour).
Country Code Country where system is installed.
Wireless Regulatory Code
A list of selectable countries. The system auto configures to the
correct regulatory approved formats and frequencies for all wireless
communications. If a country does not allow a specific wireless
communication technology then the feature is disabled, Flashpad
wireless for example.
Measurement System English or Metric.
To Next Page
Loading...
