GE Healthcare Optima XR200amx - PNF Tabs and Parameters

GE HEALTHCARE OPTIMA XR200AMX/XR220AMX
D
IRECTION 5336113-1EN, REVISION 10 INSTALLATION MANUAL
Chapter 4 Configuration Page 65
4.2.9.2 PNF tabs and parameters
Table 4-10 PNF parameters
Option Description
Named Services tab
Used to set up filters to allow traffic to common network services (such as telnet or ftp) by
name, without needing to know the port and protocol.
Services/Allowed IPs Lists current filters by name and IP.
Remove Existing Filters
Select the Delete box checkbox next to the filter to delete, then
select DELETE EXISTING FILTERS
.
Add New Filter
From the Service Name drop-down list, select the service to be
allowed (such as telnet, ssh, ftp).
In the Allowed IPs field, specify a particular IP address, a range
of IP addresses, or a masked subnet.
Select ADD FILTER
to apply your changes.
Allowed Nodes tab
Used to set up filters to allow all traffic from specified nodes. You can specify a particular IP
address, a range of IP addresses, or a masked subnet.
Allowed IPs Lists current filters by IP.
Remove Existing Filters
Select the Delete box checkbox next to the filter to delete, then
select DELETE EXISTING FILTERS
.
Add New Filter
In the Allowed IPs field, specify a particular IP address, a range
of IP addresses, or a masked subnet.
Select ADD FILTER
to apply your changes.
DICOM tab
Used to add DICOM port numbers (all IP addresses are allowed DICOM access; the DICOM
application may limit access by IP). You can add multiple DICOM ports.
Allowed DICOM Ports Lists current DICOM ports by number.
Remove Existing Filters
Select the Delete box checkbox next to the port to delete, then
select DELETE EXISTING FILTERS
.
Add New Filter
In the Allowed Port field, specify a particular DICOM port.
Select ADD FILTER
to apply your changes.
Expert tab
Used to set up detailed filters by port, protocol, and node-lock (source).
Used only by advanced IT users.
Name/Port/Protocol Lists current filters by name, port number, protocol, and IP.
Remove Existing Filters
Select the Delete box checkbox next to the filter to delete, then
select DELETE EXISTING FILTERS
.