GE M60

M60 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL 5-1
M60 Motor Protection System
Chapter 5: Settings
Settings
This chapter outlines front panel and/or software settings. The relay is not taken out of service when saving settings; the
relay is taken out of service when a settings file is written to it. Settings can be viewed remotely in a web browser by
entering the IP address of the relay, accessing the Device Information Menu option, then the Front-Panel Display Report
option.
When indicated that a restart is required for a setting change to take effect, use the Maintenance > Reboot Relay
Command in the software.
5.1 Settings menu
 SETTINGS
 PRODUCT SETUP

 SECURITY

See page 5-7

 DISPLAY
 PROPERTIES
See page 5-25

GRAPHICAL FRONT PANEL Access in EnerVista
See page 5-27

 CLEAR RELAY
 RECORDS
See page 5-39

 COMMUNICATIONS

See page 5-40

 MODBUS USER MAP

See page 5-108

 REAL TIME
 CLOCK
See page 5-109

 USER-PROGRAMMABLE
 FAULT REPORT
See page 5-113

 OSCILLOGRAPHY

See page 5-114

 DATA LOGGER

See page 5-116