GE PACSystems RX3i

GFK-2571N May 2018 101
Chapter 5 Diagnostics
This chapter describes:
• Power-up and Reset
o Module Restart
o Problems during Power-up and Reset
o Transitioning to Firmware Update Mode
• Special LED Blink Patterns
o Special LED Patterns - Module Identification
o Special LED Patterns – Microprocessor Overtemperature
• Fatal Error Reporting
• Status Reporting
• Fault Contacts and Fault Locating References
• PROFINET I/O Alarms
• The PROFINET Controller’s Local Log Table
o Local Log Table-Only Faults
o Viewing and Clearing the Local Log Table
• PROFINET Controller Faults in the PACSystems Fault Tables
o Clearing the PACSystems Fault Tables
o Faults Reported to the Controller Fault Table
o Faults Reported to the I/O Fault Table