GE PACSystems RX3i

Chapter 3. Configuration
68 PACSystems* RX3i & RSTi-EP PROFINET IO-Controller User Manual GFK-2571N
3.7.1.4 PROFINET Scanner Parameters (Module Parameters Tab)
The PNS has one module parameter:
Figure 59: PNS Parameters Module Parameters Tab
By default, the PNS module LEDs will blink a fault code if a fatal error occurs. This can be changed to cause the
PNS to restart instead.
3.7.1.5 PROFINET Scanner Parameters (GSDML Tab)
The PNS module’s GSDML Details tab displays the information from its GSDML file.
Figure 60: PNS Parameters GSDML Details Tab
This information cannot be edited.