Chapter 3. Configuration
GFK-2571N May 2018 71
3.7.3 Adding VersaMax Modules to a Remote Node
The PNS remote node can contain the module types listed in the VersaMax PROFINET Scanner Manual,
GFK-2721. However, it cannot contain the following expansion modules or communications modules:
Unsupported VersaMax Modules
Asi Network Master Module
DeviceNet Network Control Module
Expansion Transmitter Module
Expansion Receiver Module, Isolated
Expansion Receiver Module, Non-isolated
Profibus-DP Network Slave Module
To add a module to the remote node, right click on the VersaMax PNS icon in the Navigator and select Change
Module List. In the right pane of the Change Module List window, expand the list of VersaMax module types.
Figure 65: Adding VersaMax I/O Modules to Remote Node
Select modules from the list (right pane) and drag them to available slot locations in the remote node (left
pane).
Figure 66: Select VersaMax Module from Available List
To delete a module from the left-side pane, select it and press the keyboard Delete key. When the modules in
the left side pane are correctly situated, click OK to add them to the Configuration.
To Next Page
Loading...
