GE PACSystems RX3i

Chapter 2. Installation
GFK-2571N May 2018 41
2.7.3.1 SFP Modules for Ethernet Ports
Each Small Form-Factor Pluggable (SFP) cage on the bottom of a PROFINET Controller module can accept a:
• 10/100/1000 Mbps copper SFP,
• 100Mbps Single-Mode Fiber SFP,
• 100Mbps Multi-Mode Fiber SFP,
• 1000Mbps Single-Mode Fiber SFP, or
• 1000Mbps Multi-Mode Fiber SFP device.
SFP devices can be removed/replaced during module operation. The RX3i PROFINET Controller
supports the SFP devices listed below. An SFP type other than those listed below can be configured
as a GENERIC SFP in Proficy Machine Edition. The RX3i PROFINET Controller will attempt to operate
with a generic SFP that identifies itself as an Ethernet SFP. Since SFP types other than those listed
below have not been validated, correct operation cannot be guaranteed.
SFP Type
Wavelength
(nm)
Media Type
Core Size
(µm)
Modal
Bandwidth (MHz
– km)
Distance
(m)
100BASE-FX
1300
MMF
62.5
500
2 – 2,000 (Full-Duplex)
2 – 400 (Half-Duplex)
50
400
50
500
100BASE-LX10
1300
SMF
9
-
2 – 10,000
1000BASE-SX
850
MMF
62.5
160
2 – 220
200
2 – 275
50
400
2 – 500
500
2 – 550
1000BASE-LX
1300
SMF
9
-
2 – 10,000
1000BASE-ZX
1550
SMF
9
-
2 – 70,000
10/100/1000BASE-T
-
CAT5/CAT5e/CAT
6
-
-
100 (maximum)