GE Analytical Instruments ©2010 150 of 226 DLM 74001-04 Rev. A
Chapter 7: Maintenance
Figure 39: The Consumables Screen
Cleaning the Analyzer
You can clean the external housing of the Analyzer with a damp cloth using water or non-abrasive cleaners.
Turn off power to the Analyzer and disconnect it from main power prior to cleaning. Do not spray liquids directly
on the Analyzer. Wipe dry with a clean, soft cloth.
The touch screen may be cleaned with a soft cloth or cotton pad. Isopropyl Alcohol may be used, but insure that
all solvent residue is removed. Water may cause damage or discoloration of the polarizer. Clean any
condensation or moisture from any source immediately. Before cleaning the screen, you can temporarily
deactivate touch screen sensitivity for 30 seconds by selecting the following option:
1. Press the Menu button and select the Maintenance tab.
2. Press the Advanced button, press the Advanced Setup button, and then press the Clean Screen
button.
To Next Page
Loading...
