GE Sievers 500 RL - Displaying Consumables Status; Setting the Analyzer Clock and Time Zone

GE Analytical Instruments ©2010 86 of 226 DLM 74001-04 Rev. A
Chapter 4: Basic Analyzer Operation
Figure 17: The Maintenance Tab
Displaying Consumables Status
The Main screen displays an overview graphic that indicates the relative life status of the Analyzer’s
consumables: UV lamp, pump heads, and resin bed. Status indicators on the Main screen change color as the
need for replacement nears.
To display more detailed information about consumables status, follow these steps:
1. Select the Maintenance tab.
2. Press the Consumables button.
The status of each of the consumables is displayed, with an estimate of remaining life.
If you need to install new consumables, follow the instructions in Chapter 7: Maintenance for each consumable
you install; also be sure to follow the instructions in the section called “Setting the Installation or Date for New
Consumables” on page 149.
Setting the Analyzer Clock and Time Zone
You can set the Analyzer clock by following these steps:
1. Select the Maintenance tab.
2. Press the Clock button.
3. Press each date component button, enter the appropriate value, and press the Enter button.
4. Press each time component button, enter the appropriate value, and press the Enter button.