GE Analytical Instruments ©2010 60 of 226 DLM 74001-04 Rev. A
Chapter 3: Installation
2. Press the Enable Password button.
Once Password protection is enabled, you will immediately be required to log in to the Analyzer with the default
Administrator User ID and Password:
User ID: ADMIN
Password: GEAI
For security purposes, change the default password. After you have logged in using the default password, follow
these steps:
1. Select the DataGuard tab.
2. Press the Change Password button.
3. Enter the old password (GEAI) and press Enter.
4. Enter the new password and press Enter.
5. Verify the new password and press Enter.
6. Record the new password in a secure location. All users will be required to enter this log in information
to access the Analyzer’s menus.
Enabling DataGuard
If you are enabling DataGuard, follow these steps:
1. Insert the USB flash drive containing the DataGuard activation into the Analyzer’s USB port.
1. Press the Menu button, select the Maintenance tab, and press the Advanced button.
2. Press the Activate Options button.
3. Press the OK button and wait for the Analyzer to detect the USB flash drive.
4. Press the Activate button to enable DataGuard.
Once DataGuard is enabled, you will immediately be required to log in to the Analyzer with the default
Administrator User ID and Password:
User ID: ADMIN
Password: GEAI
Proceed to the section “Establishing a New Administrator Account for DataGuard” below to complete the
DataGuard activation.
After installation is complete, you can add unique user accounts to the Analyzer. Refer to Chapter 5: Password
Protection and DataGuard for more information.
To Next Page
Loading...
