NOTE: Illustration 3-6 shows the Concealment Kit frame fasten area dimensions with
example of customer supplied support frame. Any types of support frame may be
used such as suspended support frame as example 1, supporting beams as example
2, etc that meets all MR requirements.
NOTICE
Customer supplied supporting frame (wider than Concealment cover frame fasten area) is
required for Concealment Cover frame installation. If the cover frame is suspended by the four
rods only, it will be bent by the cover weight.
Illustration 3-6: Cable Concealment Kit Frame Fasten Area Dimensions with example of
Customer supplied Support Frame
NOTE: Dimensions are shown in inches. Bracketed dimensions are in millimeters.
SIGNA Voyager Pre-Installation
Direction 5680008–1EN, Revision 2
Chapter 3 Magnet Room 75
To Next Page
Loading...
