General procedures
Versana Balance – Basic Service Manual System view 4-13
5808768-100 English Rev.9
4-2-6 Initial Login to the Versana Balance R1.0.3
When first logging into the Versana Balance R1.0.3,
1. The Administrator should log in. Operator is set as “ADM” by
default.
2. You will be prompted to set up the ADM password, based on
the Highest Security Level (Default).
User could specify the Security Level in Utility -> Admin ->
User policies.
3. You will be prompted to set up 3 password security
questions and answers.
NOTE: Record your answers for the 3 questions. The answers are
required when you need to reset a password.
4. Press OK to proceed with the Logon. Press Cancel to exit.
Figure 4-4. 1st ADM Login to the Versana Balance R1.0.3
To Next Page
Loading...
